|
: Dana 300 and clocked- Grinding Noise in 4 high only? Goose 01-16-2002, 01:32 PM I have a 4.0L, 999 to a Dana 300 clocked in the second to highest position. I hear an intermittent grinding noise in the transfer case in 4 high only. It happen while wheeling in the snow. I have check the fluid and the transfer case is not hitting the body at all. Has anybody heard of this? :D yjtj 01-16-2002, 02:23 PM sounds like maybe your shifter is not engaging all the way. Goose 01-16-2002, 03:28 PM Thanks YJTJ I losened both twin sticks; slightly, they were really tight. I am going to try that and hopefully it works! Maine Jeepah 01-17-2002, 08:26 AM Yeah I would check that...the only time I've ever had any noises like that was from the dumbass that drives it not shifting it fully into place. :rolleyes: MJ Keith 06-04-2002, 11:19 AM Originally posted by Goose I have a 4.0L, 999 to a Dana 300 clocked in the second to highest position. I hear an intermittent grinding noise in the transfer case in 4 high only. It happen while wheeling in the snow. I have check the fluid and the transfer case is not hitting the body at all. Has anybody heard of this? :D Goose, grab the front driveline and wiggle it around. I'll bet the front output yoke has a bit of play. If so, pull the four bolts off the front output bearing retainer and pull shims until the play goes away, but does not make the fawker toooo tight. | |