I'm getting ready to do the hydro assist steering on the Blazer, and am trying to figure out where to drill into the box to weld the bungs in for the lines. I searched last night and found lots of pictures of where to drill if you want to do it in the caps, but the only pic I could find of a drilled box were of a Toy box. I already have to tear the box down, and am thinking about drilling the casting instead of the caps (like AGR and I believe West Texas Offroad does). Got pics?

Pete

Where were the pics of the modified Toyota box?

here is a bad pic of where to drill you can see the spots if you look carefully..

I think Scott at Rockstomper posted the toy box pic, not sure though. I think it was an IFS box? Sorry, didn't pay much attention.

Thanks for the pics, anyone else?

Pete

You can kind'a see where it is drilled in this picture.

http://www.allprooffroad.com/pics/6277.jpg

There is a rib that runs the length of the case underneath. I have been told that you can tap anywhere along there. I HAVE NOT CONFIRMED THIS:)