kirby79
06-08-2004, 09:34 PM
I have a 75 dodge 3/4 ton dana 44 front axle that I am parting out because it is not complete and I don't want to put it together.
The shaft sizes are as follows:
ds long shaft= 36 1/2 30 spline
ds short shaft= 6 3/4 35 spline
ps long shaft= 16 1/8 30 spline
ps short shaft= 6 3/4 35 spline
The shafts are still together so if you want separated let me know.
The housing has been sand blasted and primed.
The gears are a little worn but otherwise still good.
Best offer on all of the above. Location: Layton, Ut.
The shaft sizes are as follows:
ds long shaft= 36 1/2 30 spline
ds short shaft= 6 3/4 35 spline
ps long shaft= 16 1/8 30 spline
ps short shaft= 6 3/4 35 spline
The shafts are still together so if you want separated let me know.
The housing has been sand blasted and primed.
The gears are a little worn but otherwise still good.
Best offer on all of the above. Location: Layton, Ut.