I am about to make some extension cord for my Ready welder, but can't find witch end is on there (the Plug end)
I am looking here
http://www.wranglernw.com/commerce/ShowCategory.asp?CategoryID=139&Page=2

and i see a 319 series and 902 series and a 903 series,
I have no idea the differences between the 3 either
the only marking i found on my reader welder end said 175amps and 600 volts
so i am thinking the 903 series?

With a ready welder you want to have tip negitive, and put the positive line to the clamp on your work.

depends on if you're using it MIG or FCAW.

I may have read your question wrong as I don't understand what those two are talking about. ^ If you just want the connector I have had good luck getting them from forklift dealers, as pallet jacks use them for charging and have many more sizes then the ones you listed. My dealer is Darr equipment but I think they may be local dunno. Go wherever they sell Cat, Clarke or Hyster they will have it.

Mark, what are you talking about with different series? The RW or the plug ends? I've seen those plug ends at marine shops, forklift places etc. it looks like part # 34-319R in that list though.

Originally posted by mike
Mark, what are you talking about with different series? The RW or the plug ends? I've seen those plug ends at marine shops, forklift places etc. it looks like part # 34-319R in that list though.

Yeah i was a little unclear
It was that #34-319 that i needed :D
Thanks though

Cool :) hey, you need to stop by and drop off my groover one of these days... bring the RW with you, I'd like to check it out.

Just stop by your local forklift dealer and ask for a 175 amp red battery connector.
They come in different colors and the colors have to match.
Red is not supposed to be able to plug into grey and so on.
There are three common sizes for this type of plug 50, 175 and 350 amp.
I would not worry too much about the amp rating, it seems to be very conservative.
They can be prettty handy for other applications.

HTH
K.
:usa:

Originally posted by mike
Cool :) hey, you need to stop by and drop off my groover one of these days... bring the RW with you, I'd like to check it out.

I will come by today
I just got the new blades for your groover the other day
Ohh well if i dont see you on ICQ i will just stop by like 5:30 or so

COOL! :) bring the ready welder! I cant icq at work anymore. Email me your yahoo id :)

LOL that sucks,
Figure out my yahoo id
I will give you a hint

welndmn
hmmm not much of a hint huh?