Ok i read somewhere on the internet that the Oil pump bolt should be Torqued to 60 ft lbs. Then i looked in the Haynes manual and it says 115 in lbs. Logic tells me 115 in lbs = a little less the 10 ft lbs..... What do i torque this thing to?....

Thx

torque it to 'good and snug' and call it good... :flipoff2:

heh i bet it wouldnt matter if i did anyway

but i just went with this

http://www.2quicknovas.com/torque.html

For a small block 350 it is 65 ft lbs. As per my GM manual years 65 to 87. Hope it is helpful.