The new and improved FF 60/14B jig.
http://www.respite.org/images/cj66dean/60jig3.jpg

Cough up 2 Ben Franklins and you will be the only one on your block with a set.:flipoff2: pun intended
Sorry these are already sold.

This is the old set.
http://www.respite.org/images/cj66dean/60jig1.jpg

Very nice. Are those the ones for Ak boys 60? I know they said they were gettin some from you.

No. They got some inner ones for the carrier caps. They should have them about now.

top

So... $200 for the spindle ends.. how much with the pucks for the carrier caps?

Add $60

What kind of lead time Dean? I picked up a new toy and can now weld that kind of material with a mig instead of my stick.

About 2 weeks most of the time.

Excellent. I'll put some aside and let you know in probably a week or two to start makin em. I should be able to come up and pick em up.

OK I'm sorry I not too bright but what are these and what do they do??? Do they weld on in place of your old spindles to allow 35 spline shafts or what:confused:

I am interested no matter what they are

Originally posted by Supergper
OK I'm sorry I not too bright but what are these and what do they do??? Do they weld on in place of your old spindles to allow 35 spline shafts or what:confused:

I am interested no matter what they are

They align 14 bolt spindles onto the axle for welding. The 14 bolt spindles have a large enough ID to run 1.5" 35 spline shafts :D

Originally posted by mike


They align 14 bolt spindles onto the axle for welding. The 14 bolt spindles have a large enough ID to run 1.5" 35 spline shafts :D

OK thanks that is what I was hoping they were...I may just be goin to him for them???

They also work for 60 spindles too. I just bore them out to fit 35 spline axles once I have them cut off the housing. http://www.respite.org/images/cj66dean/60spindle.jpg