i was wondering if you guys can tell me what tranny can be use with a 2000 mustang with a v6 i want to build a buggy useing the motor and tanny if i can can you take off the tailcone and put like a ranger x case off i dont know much about fords

C-4 is th only thing that will bolt between a ranger T-case and mustang V-6, without any fancy adapters.

what is the name of the stick shift on it? and do you think a zuki will hole up to that motor/tranny combo

the manual tranny behind it would be a T-5.
as for a zuke holding up to it, I really don't know on that one, it depends on what axles you are runnning. But the stang 3.8 should be pretty comparable to a chevy 4.3, and lotsa of people run them.

i would just leave the aod or get a c6 and convert to 4x4 and run a 203/205 doubler or any other big ford case you want.

I would pass on the Ford 3.8. Unless of course you like changing head gaskets. My family has had a few 3.8s and every one fo them had head gasket problems.

by 2000 they pretty much got the head gasket problems licked. I wouldn't worry about it, and they grew some balls too.

its going in a buggy and i think iam going to run the 3.8 5speed then a dana 20 i got from a friend what kind of hp did they have in 2000

i believe by 2000 they were up at 200hp.. im not perfect in my mustang tech.. 2000 was the change to the new body style? (the harder edge one) if so then they definetly have the 200hp 3.8.

they go pretty decent actually.

anyone want to buy it it is in denver and i will sell it cheap

ttt