I am trying to avoid pulling the axles out of my daily Driver EB to measure, then re-install, then pull it all apart a week later....

Ordering 31 spline aftermarket axles; can anyone give me the lengths L & R, to give to the manufacturer?

The first one to respond with the right answers wins 1000 shares of Enron/ Firestone/Kmart stock--- your choice!

Thanks!

its here somewhere

http://www2.gol.com/users/neasham2/bronco/technical/interchange.html

This is the info I have on the rear ends of EB's

28 SPLINE 66-75 BRONCO:
9" small bearing R.H........29.50"
9" small bearing L.H.........27.125"
9" large bearing R.H.........29.3125"
9" large bearing L.H..........26.9375"

31 SPLINE LARGE BEARING 66-75 BRONCO: (aftermarket)
R.H.....29.50"
L.H......27.125"

31 SPLINE LARGE BEARING 74-77 BRONCO:(aftermarket)
R.H....29.75"
L.H.....27.375"

RIGHT HAND....PASSENGER SIDE
LEFT HAND.......DRIVER SIDE

LARGE BEARING DIA 3.150"
SMALL BEARING DIA 2.835"

That is great-- thanks for the help-
injectedEB, what aftermarket axles are those measurements from?

Thanks again

those were from my curries, a friend with some WH rears said his measured the same. Now that I look at it, I'm not sure why there is the discrepancy between the stock and aftermarket BB rears... I never had the stock axles in my '77 rear and forgot to measure my '74 :(.......

ok- I believe that should say '76-'77 rear BB aftermarket - at some point in there the axles did get a little longer, I know they are on the '77, just not sure where the change was.. I'll try to find out before I edit my above post...