78'fj40
07-20-2004, 09:26 PM
I'm looking for some one in the pacific northwest(prefer seattle area) who can do a proper spring-over on my fj40. Also what should I expect to pay. I'd do it my self if I knew how to weld.
|
78'fj40 07-20-2004, 09:26 PM I'm looking for some one in the pacific northwest(prefer seattle area) who can do a proper spring-over on my fj40. Also what should I expect to pay. I'd do it my self if I knew how to weld. muddogbob 07-20-2004, 09:44 PM This guy can do ya...in the portland area http://www.overthehill4x4.com/ 78'fj40 07-20-2004, 10:58 PM This guy can do ya...in the portland area http://www.overthehill4x4.com/ Does anybody have any experience with this guys work quality??? OlympiaFJ60 07-20-2004, 11:10 PM Try Randy's Off Road in Marysville, north of Everett. http://www.randysoffroad.com/index1.html Brandon eshelbyk 07-20-2004, 11:55 PM Does anybody have any experience with this guys work quality??? At some point, just about every member in Cascade Cruisers. W was the president and does quality work. helocat 07-21-2004, 01:05 AM This guy can do ya...in the portland area http://www.overthehill4x4.com/ W' the owner is a great guy and honest with the work he does. Mark 64fj40 07-21-2004, 08:27 AM S&N Fab in Marysville/Arlington. They're about 2 miles from Randy's and do far superior work IMO. They're still small enough that Trevor, Jason and Tom are the ones doing the work - not supervising a bunch of highschoolers. http://www.sn-fab.com -Eric peesalot 07-21-2004, 02:19 PM instead of paying someone to do all and send vehicle there just get a new axle housing that is already soa and has cut and turn . then just unbolt and switch everything. 78'fj40 07-21-2004, 06:17 PM instead of paying someone to do all and send vehicle there just get a new axle housing that is already soa and has cut and turn . then just unbolt and switch everything. But the real question is where do I find such an axle? OlympiaFJ60 07-21-2004, 06:47 PM But the real question is where do I find such an axle? Check manufacturers corner on IH8MUD forum, look for Profits Cruisers. He is a member here too I think. He does a cut and turn front axle, then you send your old one as a core. Brandon 78'fj40 07-23-2004, 07:23 PM Thanks for the posts. :) I guess I"ll have do do a little research on some of these shops. TLCObsession 07-23-2004, 11:28 PM But the real question is where do I find such an axle? Get one from Steve at Extreme Bends just up across the border. I would do a SOA but I am just too busy. I do have an old rear housing that is setup both ways.... I also have one with a great track bar that I would sell. JIm | |