I am trying to put together my 4.6 stroker and am having trouble getting my crank put it. The #7 bearing/cap seems to be too wide and wont fit on the crank. The crank is a later model 258 crank (so I don't have to trim the snout down). The other 6 bearings and caps fit perfectly and the crank fits in the block without the #7 bearing in place. Anyone have any ideas what to to here?? I am trying to get this done and get my Jeep back on the road (been down all summer and its by DD). This petty shit sucks :flipoff2:

update:
I think I got it.. dumbass mistake :p :flipoff2: