|
mikesimpson 08-10-2004, 08:07 AM I'm putting an NP435 behind my Jeep 4.0ltr, and using a T150 bellhousing, and I can't remember which CJ slave cylinder to use for the clutch fork. I know it's either the CJ 4 cylinder, but I forgot if it is the GM 4-banger or the non GM 4-banger.... And what year range??? Thanks. ddestruel 08-10-2004, 08:40 AM 80-86 used the 151 Iron duke and a hydraulic slave Jaffer 08-10-2004, 08:59 AM The hydraulic clutch setup (MC, slave cyl. & hose) was original equipment on a 1980-83 GM (Non-AMC) 4 cylinder jeep engine. ddestruel 08-10-2004, 09:23 AM My bad oops mikesimpson 08-10-2004, 10:56 AM So to re=cap/ or state the blatantly obvious, I need a slave cylinder for an 80-83 CJ with a 4 cylinder, non-AMC motor? Thanks. ddestruel 08-10-2004, 11:15 AM correct it is the 151 cu i motor for those years which is a GM motor not an AMC mikesimpson 08-10-2004, 01:41 PM :D THANKS! :grinpimp: | |