|
: Need help with a SPICER part# HeyBeerMan 01-25-2002, 08:44 AM I need the part number or numbers for the following: Yoke to fit a 1350 U-joint That would go in a Dana 60 front diff out of a 1984 GM P/U TIA onetoncv 01-25-2002, 08:55 AM they only make those from dana strap style unless you modify it- and angle is limited at 20 degree's with out grinding- the part # should ba a 3-4-5731-1x -again this is the strap style- Jess Shaker 01-25-2002, 09:11 AM Onetoncv has the right info.....I must add 1 thing. STRAPS SUCK, STRAPS SUCK, STRAPS SUCK......get the u-bolt style its stronger. Are you sure the yoke is a 1350? The yoke on my 60 was smaller than 1350.... HeyBeerMan 01-25-2002, 09:13 AM Originally posted by Shaker Are you sure the yoke is a 1350? The yoke on my 60 was smaller than 1350.... That's why I'm looking for one to fit a 1350. :rolleyes: :flipoff2: Shaker 01-25-2002, 12:25 PM Originally posted by HeyBeerMan That's why I'm looking for one to fit a 1350. :rolleyes: :flipoff2: :flipoff2: :flipoff2: Back to ya!!! Call "Onetoncv" aka-Jesse and order one....:flipoff2: (530)877-2875 in Cali. PS: :p :flipoff2: :D Eric 01-25-2002, 01:06 PM I think Chevy used 1310 on the front D60. How much are the 1350 u-bolt yokes? Did they ever come on any other axle? D70 rear? Shaker 01-25-2002, 01:30 PM Originally posted by HeyBeerMan That's why I'm looking for one to fit a 1350. :rolleyes: :flipoff2: looky here from jesse's site http://www.highangledriveline.com/1350%20+%20larger%20end%20yokes.htm HeyBeerMan 01-28-2002, 05:54 AM Originally posted by onetoncv they only make those from dana strap style unless you modify it- and angle is limited at 20 degree's with out grinding- the part # should ba a 3-4-5731-1x -again this is the strap style- Jess Thank's for the info Jess. I'll be calling you today on a driveline. | |