|
zags 01-25-2002, 12:46 PM O.K. I've snuck over here from the Toyota board, I am thinking of coming over to the Zuk side, Does anyone run a toyota 22re in thier zuk? How about dual Toy cases? I can get a non running sami cheap, and am contimplating putting my Toy drivetrain in it. any ideas? suggestions? rotozuk 01-25-2002, 01:16 PM It will be a tight fit, but well worth the effort. I'm currently working on my rotary engine/4 speed auto/twin toyota t-case/toyota axle set up. Motor and tranny mounts are done, and just put in the Toyota rear axle last night. Still looking for the rest of the needed driveline parts. To fit it all in, I'm stretching the Zuk a bit, but you might be able to get away with it running all Toyota. -Wayne Azrckcrawler 01-25-2002, 01:50 PM Originally posted by zags O.K. I've snuck over here from the Toyota board, I am thinking of coming over to the Zuk side, Does anyone run a toyota 22re in thier zuk? How about dual Toy cases? I can get a non running sami cheap, and am contimplating putting my Toy drivetrain in it. any ideas? suggestions? Someone around here was working on just that. If you do it let me know, I'd love to take pics and help out. 0ILBURNER 01-25-2002, 02:07 PM Found MANY posts on this subject on my 1st search try::rolleyes: Toyota engine (http://www.pirate4x4.com/forum/showthread.php?s=&threadid=18433&highlight=toyota+motor) zags 01-25-2002, 02:21 PM Originally posted by 0ILBURNER Found MANY posts on this subject on my 1st search try::rolleyes: Toyota engine (http://www.pirate4x4.com/forum/showthread.php?s=&threadid=18433&highlight=toyota+motor) Gee, why didn't I think of using search?:rolleyes: I read that one, it is for installing a 3te motor with a zuk case. Nevermind, I can figure it out for myself. I need 75 in. from the front of the rad to the rear output flange. 0ILBURNER 01-25-2002, 02:34 PM My bad, dude. I was trying to help - Meant This: Toy Eng in Zuk (http://www.pirate4x4.com/forum/search.php?s=&action=showresults&searchid=40227&sortby=lastpost&sortorder=descending) Here's you a contact who has actually done it: Green Zuk (al@4offrd.com) Azrckcrawler 01-25-2002, 04:02 PM :laughing: Hey Zags, we are normally not so jumpy in the Zuk section, there's been a couple newbies in here so there's still some blood in the water :D JackA 01-25-2002, 04:53 PM You could always run the earlier model Toy tranny. It's like 5-6" shorter. I think they might be 4 speeds, but who uses 5th anyways. :smokin: fatkid 01-26-2002, 10:49 PM I use 5th...:flipoff2: flexlarson 01-27-2002, 10:38 AM I have a couple pics on my site. No real info yet www.rollover.at/midwestzuki | |