|
DRGRDRJR 08-19-2004, 09:50 PM I'm trying to install a dual steering stabilizer on my 90 Sub. Only I can't seem to remove one bolt from the stock stabilizer. The bolt that goes to the tie rod. I removed the nut that has the cotter pin but the bolt wont come out!!!!! pcorssmit 08-20-2004, 08:31 AM I would take it to Four Wheel Parts and let one of the pros do it. Pete cegusman 08-20-2004, 11:48 AM Use some blinker fluid for lube and it should come out. Juice 08-20-2004, 01:08 PM B. F. H. !! (aka big fawking hammer!) and a cheater bar! :flipoff2: DRGRDRJR 08-20-2004, 02:02 PM I wasn't sure if that bolt was threaded into the steering tie rod! Could I damage the alignment of I use brute force on the bolt? keller 08-20-2004, 03:41 PM just beat the fuck out of it it will come out what you realy need is a ball joint separatior to beat in there but you will be fine put the nut back on the bolt ( just a few threads dont bottom it out) and beat the nut it will pop DRGRDRJR 08-20-2004, 04:01 PM Yeah, thanks.... I just found out I could get a loaner specialty ball joint separator from a local parts store..... Thanks everyone for your input...... blacksheep10 08-20-2004, 04:14 PM I would take it to Four Wheel Parts and let one of the pros do it. Pete That's funny :laughing: :laughing: :laughing: :rolleyes: DRGRDRJR 08-20-2004, 09:37 PM Quote: Originally Posted by pcorssmit I would take it to Four Wheel Parts and let one of the pros do it. Pete That's funny __________________ You don't pay a prostitute for sex..... You pay her to LEAVE Yeahh I know............. :flipoff2: DRGRDRJR 08-20-2004, 09:45 PM Quote: Originally Posted by pcorssmit I would take it to Four Wheel Parts and let one of the pros do it. Pete That's funny __________________ You don't pay a prostitute for sex..... You pay her to LEAVE Yeahh I know............. :flipoff2: "People who drink light "beer" don't like the taste of beer; they just like to pee a lot." | |