I have put a (front)dana 60 out of a dodge in my 74 Jimmy and i have had a hell of a time finding brakelines for it and i would rather just buy some and not have them made does any one know where i can find any(besides the skyjacker ones) because every place i have gone and asked for them, i dont know y but they r rear brake lines(I think somone messed up at the old packaging plant hehehe)? :evil:

74 Jimmy/454/np 205/TH 400/40 inch swampers.

Dodges typically run 1 brake hose from the engine crossmember to a T-fitting at the center of the axle. Then hard lines run out to each wheel where another brake hose connects to the calipers. On your Chevy, you just have a long brake hose on each side that runs from each frame rail right to the calipers right?

Couldn't you just buy a set of brakes hoses for late 70's or early 80's Chevy one ton and bolt them up? I think the Dodge and Chevy Dana 60 calipers are the same.

If you are looking for a longer brake hose get one for a 2wd Chevy 1t. they are longer than the 4 wd. IIRC there are a couple different hoses available for the '70s and '80s versions, the differences being the size of the hole in the banjo fitting at the caliper end of the hose.

Gus