As it says, i have found the poinson Spyder sliders but would like to find a bolt on similar to the warn or sun performance.

Now im not discounting the PS and may go that route but in all my searching i have not been able to find a slider that has the built in roll like the Warn but also bolts flush and Does not have the potruting rail welded on. Just thinking and searching out load and i am still a few months away from finishing the body work and engine install now so suggestions are welcome.

As to building my own i may do that, just break some steel but the bolt on do hickies have the Bling Bling that i might want to add

what kind of bling add-ons are you talking about?

I made mine. Couldn't find what I wanted on the market. Had a local metal shop with a huge brake bend them up for me. They go under the tub all the way to the frame. Made from 3/16" plate. Have held up well to some severe beating.

what kind of bling add-ons are you talking about?


I always have thought of the bolt ons as flashy over just using angle iron kinda a far fetch on bling bling but still cool over an old piece of cold steel

What is the width of the axles on that scrambler? clean looking setup love the coils and links too..... I'll get more creative once she is up and running

ooook, i got it now. in that case, get some box tube and with an cutoff wheel just cut through one side halfway in between the width all the way down, then another side next to it...sort of notching out a smaller square. with that small angle (say it's 2"x2" box, measure in 1", and cut all the way down, then rotate the tuube 90, measure in 1", cut that line) out, butt the larger piece up against the angle, weld it, prep, and paint it.not round, but still a little more special looking then plain angle.

i can make you a set if you're interested. PM me.

61" wms to wms

thanks

Try Hanson Enterprises. They have some stuff like that. They also have a custom shop and I believe they built the designs that many others sell.

Hanson Enterprises (http://www.hansonenterprise.com/index.htm)

made mine too. if you are interested, i can provide you with the flate pieces that bolt to the tub (and body mounts if you want) and you can weld whatever steps you want to them.

i decided to angle my steps down at a 45º to make them more useful as a step. they work REALLY well! the tubing is 1.75" od x 0.134 wall tube...it will take a pretty hard hit to bend or dent them. if you have any other questions, let me know and i'll try to answer them. i have some better pictures of them at home and can post them if you'd like.

Matt