What are some of the price ranges for hy-steer arms? Who has the cheepest and what are the steepest?

What are some of the price ranges for hy-steer arms? Who has the cheepest and what are the steepest?

Remember what happened last time we bought cheap arms??

The Sky Manufacturing arms look like the best bang for the buck, $75 for flat and $85 for tall.

When we go wheelin do you two mind driving ahead of me I wouldnt want to get in your way :flipoff2:

I would hope that just because someone is selling cheaper doesnt meant they were made cheaper.

When we go wheelin do you two mind driving ahead of me I wouldnt want to get in your way :flipoff2:

I would hope that just because someone is selling cheaper doesnt meant they were made cheaper.

They are good arms, the fit and finish isn't there. Took all day to make them work:D:D

Not to distract from your post but how is the FI problem going?

OH and you missed out on a good weekend of wheeling. We had a Scout guy changing Birf's.

Not to distract from your post but how is the FI problem going?

OH and you missed out on a good weekend of wheeling. We had a Scout guy changing Birf's.

this is true...just don't tell them what I had to do for the replacement.

These arms look good too, too bad they are set up for heims instead of TREs. http://www.pirate4x4.com/forum/showthread.php?t=284122

My poll awhile back was putting OTT at the top and Sky right behind......I think I will roll with Sky because OTT is $$$.

My poll awhile back was putting OTT at the top and Sky right behind......I think I will roll with Sky because OTT is $$$.
Actually, Parts Mike was on top in your poll and by a large margin :D
http://www.pirate4x4.com/forum/showthread.php?t=264990

I make these 1" step arms out of 2" X 2" c.r.s .
You chose the number of holes and what type , tie rod end or heim .
$240.00
:grinpimp:

I will sell you a set for $120. They are flat with TRE holes and flame cut profile. I don't have any pictures of them yet but I could get some in a day or two. I will even throw in a pair of my new 1/2" spacers if you need them.

found these today at blue torch fab for $67.50

http://www.bluetorchfab.com/oscomm/catalog/product_info.php?products_id=309&osCsid=241e357bad8682de00bd26244085f3d9

http://www.bluetorchfab.com/oscomm/catalog/images/dana44ARM2.jpg

Will any of these arms fit hummer wheels?

I've seen these from Parts Mike. They look shorter and have a angle at the end for?
http://img45.exs.cx/img45/3948/PM_YJ_arm.jpg

I also run the Parts Mike "Superarms" and very pleased.

The angle at the end is to lessen the approach angle on the TRE to help it last. This is what I recall from asking Mike the same question. I'm also running the solid rod tierod from the '76-79 Waggoneer cut down at Mike's suggestion which makes the steering very flat and tight combined with a Skyjacker 4" dropped pitman and custom drag link.

Good luck.