As you can see from the picture I have no info to go off of. I need some basic wiring help. This is the solenoid from the hydro steering in the rear of my parts truck. I want the wheels straight but I can't move them without the solenoid hooked up. Anyone know what wires should go where :confused: I have a new double throw switch to use.
http://users.adelphia.net/~mikerampino/Jeepstuff/Solenoid.JPG

Anyone??

Anyone know what wires should go where :confused:
There is only three termamls!
High amp in (Goes to battery) (large wire)
High amp out goes to pump Looks like a copper lug in the pic
Activation termainal. Small 12-14 gauge wire.

So theres no ground?
Hope I didn't fry the thing :nuke:

So theres no ground?
Hope I didn't fry the thing :nuke:
It grounds thu it's body. .

Thanks, I'll see if I can get it going as soon as it dries up outside.