|
jeepmodman 02-01-2002, 04:52 AM i just put an atlas 2 in my heep with a D 60 front and the driveshaft looks like something out of a chromed out show truck with 2000 inches of lift how do i cut the cast-in perch on the passenger side to tilt the pinion up to 20- 30 degrees without using a milling machine:beer: Scout Dude 02-01-2002, 06:42 AM Grinder....sheesh:rolleyes: mj 02-01-2002, 09:12 AM circular saw with cutoff wheel GloNDark 02-01-2002, 09:16 AM Originally posted by Scout Dude Grinder....sheesh:rolleyes: Grinder, patience...and lot's of :beer: Take your time. You're not going to win any races with it. :D:D: Shaker 02-01-2002, 09:24 AM Originally posted by jeepmodman i just put an atlas 2 in my heep with a D 60 front and the driveshaft looks like something out of a chromed out show truck with 2000 inches of lift how do i cut the cast-in perch on the passenger side to tilt the pinion up to 20- 30 degrees without using a milling machine:beer: Why not rotate knuckles........ran outta $$$ after Atlas huh...... jeepmodman 02-01-2002, 09:38 AM i will rotate the knuckles after the pinion points up in the air Tony Sobrito 02-01-2002, 10:44 AM Originally posted by jeepmodman [how do i cut the cast-in perch on the passenger side to tilt the pinion up to 20- 30 degrees without using a milling machine:beer: [/B] i did my 60 freehand with a makita 4" and made a 15 degree change to the pad angle. at night i dream about mills now. | |