msuforeman
10-30-2004, 11:01 AM
Do I reuse these washers when installing the lockright? They were originally next to the spider gears.
http://www.supermotors.org/getfile/154426/fullsize/Lockright%20install%20001.jpg
http://www.supermotors.org/getfile/154427/fullsize/Lockright%20install%20002.jpg
http://www.supermotors.org/getfile/154428/fullsize/Lockright%20install%20003.jpg
Nobody
10-30-2004, 11:03 AM
Yes, those are your thrust washers. I recommend replacing them with new ones. If the tolerances aren't right on the lockright, you might have problems with it not unlocking, or not locking. Make sure you check as noted in the instructions.
msuforeman
10-30-2004, 12:05 PM
Are you sure these are not the thrust washers?http://www.supermotors.org/getfile/154433/fullsize/Lockright%20install%20004.jpg
DRKelly
10-30-2004, 12:45 PM
It was over a year ago since I put mine in and I can't remember. I do remember wondering the same thing though. The lock right gives you a dimension to check once assembled. I think I put it in and checked that and then knew if I was off or not about having them or not having them. Read through the installation instructions carefully and be sure to check that dimension.
DK
Nobody
10-30-2004, 02:38 PM
Duhh.....the ones in your hand are the thrust washers for the side gears that you keep. The others are for the actual spider gears. Throw those away. Sorry for the confusion.
Oatmeal
10-30-2004, 05:22 PM
Do I reuse these washers when installing the lockright? They were originally next to the spider gears.
http://www.supermotors.org/getfile/154426/fullsize/Lockright%20install%20001.jpg
http://www.supermotors.org/getfile/154427/fullsize/Lockright%20install%20002.jpg
http://www.supermotors.org/getfile/154428/fullsize/Lockright%20install%20003.jpgThose are for your spider gears, since you wont be re-using the spider gears........... :rolleyes: .......Hans