My buddy has a msd ignition system on his zuk and his #2 plug is getting cooked. The material (porsulon?)around the electrod is melting away and its only on #2 . Any suggestions?

TECH LINE: (915) 855-7123
MSD TECH LINES are open Monday thru Friday from 8am to 5pm Mountain Standard Time


Sometimes our techs may need more information about your application or, can give a more thorough answer by talking with you. For lengthy questions, please include a phone number that you can be reached at in your email.

MSD technical questions by :
msdtech@msdignition.com

Note: Due to the volume of e-mail our Tech Department receives it may be up to 48 hours before you receive a response. We will definitely get back to you!
Also, if you email a question then follow up with a call, please write our "msdtech" a short note that you received an answer over the phone. This will save our technicians time. Thanks.


Hope this will help.......Kerry @ SOS

Not sure if this may have anything to do with it or not but i had a Ford ranger that the #2 plug wire rubber around plug was literaly turing to goo truck ran ok but not great Found the head gasket blown and hot exhaust gas most have been hitting it right there maybee something to look at take a compression test ???????

Sounds like you may have somthing wrong...:flipoff2:

Not to Change the subject but hows the bendin comin Fatkid ?:smokin: :D

It's good, didn't get much done this week though cause I've been sick. But I'm off the death bed and I'm heading into the shop today to make up some work I missed...:smokin: