I ran this setup on my YJ with a ford 60, with chebby outers, so it may need to be modified to work with other stuff, but I have what I am pretty sure is 1.25" solid rod tie rod with a bend in it to clear the pitman arm on compression, and the draglink is straight... I can get measurements if there is any interest. running the big Moog 1 ton TREs everywhere with the nifty tre that you hook the draglink into on the passenger side of the tie rod. Ran this setup for 2 years and no problems whatsoever, just went full hydro so I dont need any of it anymore...

Also have some rock equipment high steer arms with GM large taper sell for 99 new, Ill let em go for 75.

$220 obo takes it all, or 150 for everything but the steering arms. will get measurements if any interest. Will try to have pics up later tonight.

ttt

gpt a pic of the steering arms?

Heres a couple pics. The steering arms have a very light amount of surface rust could easily be cleaned with a wire wheel but Im lazy, the tie rod and drag link have a couple scrape marks but nothing bad and they are still straight. the tie rod is about 52.5" eye to eye with 6 or 7 threads showing on the tres and the drag link tube(not including tre's) is 26.75"

200 for all, 140 for everything except the arms, or make an offer come awn :flipoff2:

im interested in the arms how far is it from the center of the tre hole to where the center of the kingpin would be ?

about 6"

ok how much for both arms shipped to 42240

90 bucks if you want to paypal send it to bermboy@hotmail.com otherwise send a check or Money order(parts will ship as soon as payment clears) to
Scott Maiden
2825 N. Villas Lane
Chandler, AZ 85224