|
71-Cruiser 12-06-2004, 02:22 PM If any one has one or two laying around I would be interested. I was going to carry one as a spare in case i blow up a warn hub with my longs. Thanks Michael michael.harness@ferguson.com John Smith 12-06-2004, 02:48 PM IIRC they are not that much from the dealer. Otherwise post over in the wanted section and you may have some luck. The 80s section over on ih8mud is probably also a good spot to post. Or you could always find an 80 at the mall... they would probably not notice they were missing. :flipoff2: peesalot 12-06-2004, 03:06 PM Randy's ring and Pinion has em for a good price. They will press dust shield on and the flange has both bolt patterns in it. Landpimp 12-06-2004, 03:09 PM about $30 from Toyota for a 80 series drive flange. Watch out for used 80 series flanges, they may have some wear, I know mine did. cruiserbrett 12-06-2004, 10:06 PM Randy's ring and Pinion has em for a good price. They will press dust shield on and the flange has both bolt patterns in it. I dont think he means pinion flange, which is what I am guessing you are talking about. fj40charles 12-07-2004, 06:31 AM I go with some Aisin hubs. Warn's are not known for their strength. tornadoalleycruiser 12-07-2004, 08:39 AM Course spline? or Fine? Landpimp 12-07-2004, 08:47 AM sig line says disc brake front end, so I asume fine spline Course spline? or Fine? 71-Cruiser 12-07-2004, 11:32 AM Yup they are fine. I will take a set of Asin hubs if anyone has some for cheap as well but i figured i could postpone that expence for a while with some drive flanges. Jason M 12-07-2004, 05:45 PM BTW, work out 80 series hubs work great on a 40. The slop is no big deal on a non Full time 4wd truck.. | |