I have a set of oem chevy flat top knuckles. They are both milled and tapped for high steer arms. They are bare, no studs or ball joints or anything. I want $125 for them.

I also have a set of welded steel knuckles from rock equipment. You can see them at http://www.rockequipment.com/images/d44superknuckle3.JPG
I don't remember the condition of the ball joints but believe them to be fine. They have high steer arms on them also from rockequipment. They are drilled for 3/4 heim joints. The arms new are listed at $109 each without studs or taper washers. They are the ones with the 10 degree taper milled into them. I don't remember for sure the price of the knuckles new since they now sell crane knuckles instead.The only thing different on my set of knuckles is that since I was running them with 8 lug rotors I bought them without the brake tabs welded on so I could run factory 8 lug caliper brackets. I'll sell the whole set for $350

The best way to reach me is at emick@sbcglobal.net

Thanks

top

"I have a set of oem chevy flat top knuckles. They are both milled and tapped for high steer arms. They are bare, no studs or ball joints or anything. I want $125 for them."

Interested in these. Im in Rocklin so close. Verify if these will work on chevy 8 lug 44?

richhoov@earthlink.net

are the knuckles both driver side, or is one a passenger side. I need a passenger side flat top knuckle. if you have one I am interested.if so how much.

Looking for passenger also if you want to split them up. OEM preferred.

If you'll split them up how much for the Dside?

you still have these?