Thinking of getting the summit block hugger headers before I have my exhaust made- but on their site they mentioned that the headers don't fit with side engine mounts. Just checking to see if anyone has used the block hugger headers with the Advanced Adaptors sb350 engine mounts in place. Thanks in advance-

They told me that too when I ordered the hugger headers from them.....mine fit great. Summit does have a free return policy if they happen to not work for you. Can't see why they wouldn't tho.

no problems with mine.

I bought the Dynomax block huggers and some tubes that they sell to tie in block huggers to your exhaust. Made it really easy to build an exhuast system.

-Stumbaugh

I had a pair of the block huggers laying around in my garage and was gonna use them when I did my 350 swap. I ended up not using them becasue they were extremely close to the starter. GM starters are notorious for crapping out early due to excessive heat, I didn't want to deal with this on the trail. I opted to use ram horns instead. They flow pretty much like headers, and the exhaust was a snap to route. Just my preference, take it for what its worth..............:skull:

I am also using A/A motor mounts ,block huggers would not work for me.I still have manual sterring the header on the driver side would not fit because of the sterring box. I installed ramhorns and no problems.