tobbjo
01-27-2005, 01:32 AM
Rented plasma in last weekend and made up three bumpers/recovery points/steering guards for RRC.
With the Plaz it's such a breeze to make fancy graphics. My imagination/artistic is not the best. Any ideas? I want some nice holes in the front part of the steering guard.
Pleas keep in mind it has to be fairly coarse, since the plaz has a 10mm nozzle and the cut itself is 2-3mm wide.
The steel plate for the steering guard is 5mm high tensile (650MPa), the mounting irons are 6mm Hi Tensile while the bumper itself is 3mm normal sheet.
Idea so far is
Range :D Rover
I thought about
Range :flipoff2: Rover
but it is not very well known and might be too offensive for most swedes :rolleyes:
Pleas not just 5 round holes in a row!
Tobias
With the Plaz it's such a breeze to make fancy graphics. My imagination/artistic is not the best. Any ideas? I want some nice holes in the front part of the steering guard.
Pleas keep in mind it has to be fairly coarse, since the plaz has a 10mm nozzle and the cut itself is 2-3mm wide.
The steel plate for the steering guard is 5mm high tensile (650MPa), the mounting irons are 6mm Hi Tensile while the bumper itself is 3mm normal sheet.
Idea so far is
Range :D Rover
I thought about
Range :flipoff2: Rover
but it is not very well known and might be too offensive for most swedes :rolleyes:
Pleas not just 5 round holes in a row!
Tobias