Dustin
01-31-2005, 08:14 PM
I have a set of welded steel knuckles from rock equipment. You can see them at http://www.rockequipment.com/images...perknuckle3.JPG
I don't remember the condition of the ball joints but believe them to be fine. They have high steer arms on them also from rockequipment. They are drilled for 3/4 heim joints. The arms new are listed at $109 each without studs or taper washers. They are the ones with the 10 degree taper milled into them. I don't remember for sure the price of the knuckles new since they now sell crane knuckles instead.The only thing different on my set of knuckles is that since I was running them with 8 lug rotors I bought them without the brake tabs welded on so I could run factory 8 lug caliper brackets. I'll sell the whole set for $300
The best way to reach me is at emick@sbcglobal.net
Thanks
I don't remember the condition of the ball joints but believe them to be fine. They have high steer arms on them also from rockequipment. They are drilled for 3/4 heim joints. The arms new are listed at $109 each without studs or taper washers. They are the ones with the 10 degree taper milled into them. I don't remember for sure the price of the knuckles new since they now sell crane knuckles instead.The only thing different on my set of knuckles is that since I was running them with 8 lug rotors I bought them without the brake tabs welded on so I could run factory 8 lug caliper brackets. I'll sell the whole set for $300
The best way to reach me is at emick@sbcglobal.net
Thanks