PIG
02-01-2005, 09:02 PM
The BADDEST FJ-80 Front Inner Axles Ever Made-
THE LOW DOWN-
-CNC machined from high quality 4340 material.
-Induction heat treated.
-Total elimination of stock spline void (serious stress riser).
-The od of the shaft (on the area between the seal and the diff side) splineis machined to match the minor diameter of the BIG 24 spline side of the axle.
-The od of the shaft between the seal and the birf side ramps up to the seal OD to localize the load to the largest area of the shaft.
-BITCHIN FACTOR................................. = 9.99
PRICING:
$300.00 per pair....(quantities are limited)
Call to order....805-783-2060
THE LOW DOWN-
-CNC machined from high quality 4340 material.
-Induction heat treated.
-Total elimination of stock spline void (serious stress riser).
-The od of the shaft (on the area between the seal and the diff side) splineis machined to match the minor diameter of the BIG 24 spline side of the axle.
-The od of the shaft between the seal and the birf side ramps up to the seal OD to localize the load to the largest area of the shaft.
-BITCHIN FACTOR................................. = 9.99
PRICING:
$300.00 per pair....(quantities are limited)
Call to order....805-783-2060