Can somebody take a tape measure to a disassembled 60 front, low pinion? I need to know distance from: flat cast surface parallel with pinion, just inboard of right side (left when viewed from front) carrier bearing boss; to: the innermost edge of the inner pinion bearing bore.
So basically if you stuck a tape in the housing and jammed one end right next to the carrier bearing area of the housing, over to the the edge of the pinion bearing bore. Or, to the pinion centerline if that's easier.
Thanks, I'm trying to figure something out on this POS 61 front that the BOM number isn't helping with. :beer:

if you are trying to find out what size ring gear spacer to get call Drivetrain Direct and give them the BOM they can hook u up (they did me...(on the rear Ford 61 i have)