How hard would it be to swap a dana 44 from a chevy to a 5 on 5.5 bolt pattern?

Not very.








oh, we're you looking for how to do it? I had hubs redrilled once upon a time. Two of them cost ~$100 a few years back. Any competent machine shop can re-drill them.

Or you can get spacers with a different pattern from hub side to wheel side.

Or you can buy different hubs with the pattern you desire. Either new or used. If you look hard enough, you might even find somebody around here that is going the opposite direction and just swap parts.

-tom

If you'll search the Jeep board you'll find at least a dozen threads describing in detail just how this is done.

In fact, I think I've seen it on every board I frequent.

Do a Google search for Mr. N's dana 44 articles, he describes how to do it.