put the dana 300 in and now I am deciding how to route my exhaust. before I take it some whereI would like some opinions. the only give is that the muffler and cat have to be on the driver's side. no biggie.

the question is what to do after that. should I cross back over the width of the jeep and come out the stock YJ location or should I angle it back out behind the rear drive's side tire?

has anyone else done this, pictures would be greatly appriciated!!!

I know it sounds like a no brainer but I jsut wanted to check to see other opinions before I pay for it.

The guy that did my exhaust was able to fit the pipe on the outside of the Dana 20 (same setup basically), and still fit everything pretty nicely. I even had to run dual cats (waited too long to have the exhaust done, so I had to do it in NC where they require everything instead of doing it in Michigan where I would have been able to get by without) and they fit, too, but he did end up having to use 2" pipe instead of 2.25" like I wanted. Not sure what the problem was there, though.

If it were light out, I'd snag some pics....

Matt