|
: instaling a early manifold on a chevy 350 Land Crusher 02-19-2002, 09:50 PM I cant remember if i can do this or not ? I have acuired a 1987 chevy 350 I have a early holly torquer intake can I make it fit ????? THANKS Keith 02-19-2002, 10:52 PM I dont think they went to an eight bolt manifold until 96. If it has 12 bolts, then look at the center two on each side. I have an '80 where the bolts are all at the same angle. My 92 has the center two bolts at a different angle than the rest. If the angle and the number of bolts is correct, then it should bolt right up.... Hillbilly 02-20-2002, 03:09 PM How about this, I did just the opposite of what you're asking about. I put a 87 intake on an early model motor. I machined the intake holes out bigger and used hillside washers and made it fit. Maybe this will help you. | |