allright well i recently bought a yj and did a soa lift on it, i have about 25" from the ground to the frame. my question is can i run 35's with out trimming my wheel wells? anyone else done it?

35's won't physicly fit in the wheel wells without minor trimming... if you don't want to trim you obviously to worried about cosmetics to need a SOA suspension or 35's

i run an soa on 35's with 2 inch springs, ill be stepping up to 36"swampers when i can afford it. put in an aal and go for it, youll be able to fit 35s then

TJ flares.. :flipoff2:

TJ Flares look niiiiiiice.

WTF kind of gay question is that? I fit 35's fine up front SOA on stock negative arched springs.

http://onclickpix.com/13638.jpg

I fit 35's with SUA and no lift... or at least very little...
http://www.pirate4x4.com/forum/attachment.php?attachmentid=176913

Come on man, you have to at least search a litle bit. I'll throw you a bone, cut the eyes off another set of stock YJ main leafs and insert them under your main leafs, TJ flares, and you are good.

Why not just trim em up. We run 38's on a yj w' spring over and a 1 inch body lift and the tires clear fine. They look better chopped IMO.

To answer your question yes 35's will fit on a soa with stock springs and no trimming.

I had to trim mine a little. Even with 1.5 inch RE SOA springs. Guess everyone's set up is a little different.

To answer your question yes 35's will fit on a soa with stock springs and no trimming.

I guess this is true... but your fenders will get munched without trimming unless you run some serioulsy tall bumpstops

i run 35s SOA with 2.5" OME springs. front Rub the fenders a little. put bigger bump stops and call it good or go flatty

I run 33s with a 3.5" SUA and do not rub even w/o bump stops on the axles. I could fit 35s by fender trimming so 35s should clear easy with SOA. Hell, trim fenders and go with 37s. :shaking:

same here right now im running 33s on 3"sua,, when i play to go soa ill run 37s.

It really just depends on your springs. Put on the 35's, and if they don't fit get some 2.5" springs.

well its my daily driver so i need fenders on it. and it doesnt look like i can fit 35's if i have my fenders on

well its my daily driver so i need fenders on it. and it doesnt look like i can fit 35's if i have my fenders on


I have a 1986 CJ7 that I did a SOA on and it has 25" from the bottom of the
frame to the ground. I run 36x13.50x16 IROKS and don't get into the fenders.
YJ's have more fender clearance than a CJ. I doubt you'll have a problem with 35's.
BTW, my 36" IROKS actually measure 36.75" tall. Most 35's measure around 34".

you don't have to take your fenders off to clear 35's you just need to trim a little out of the rear of the rear fender openings... not sure how much is necassay but to actually be able to get 33's to tuck into the fenders without rubbing the trimming is still covered by the stock flares

:cow:

If its not enough do a shackel lift cheap and e-z

i had stock springs with a soa and fit 35 fine and had room for flex to. i would recamened putting some different springs in the front. rears have one more leaf and may hold up better. my stock fronts had a negative arch just sitting on flat ground.