Currie ford 9" axle shaft 31 spline (read for specs)

[sfazr2]

length :30" (end to flange outter face)
bolt pattern:5 1/2"
splines:31

Kicker: the last half inch is stripped. He would've tried to warranty it but he would've had to order one with another 1/4" longer or so ("so we're warranting an axle shaft that was too short?" ....get it) It still has 1 3/4" of engagment so technically it could be cut down to a 29 1/2" axle shaft.

If you want to pick it up...totally free. If you want me to ship it, you pay for shipping and a couple of $$ for my time would be good karma. I couldn't see a good axle go to waste.

408-685-6726

[2xs]

How about my door panels?

its been over a year.....

[sfazr2]

good point, considering I'm moving, it'd be good to have one less thing to pack. Did you ever use the bed panels?

[2xs]

I dropped a couch on one in the garage.
basically trashed, pissed me off too, as I was about ready to start the project.

Deciding to do a flatfender instead....

[sfazr2]

Whats your address again?

[hotwheelsYJ]

If it's an alloy shaft, I'll take it.

How much to ship to 37312?

[sfazr2]

2XS- I shipped your panels on thursday the 21st, sorry I didn't have time to clean them up, hope you can use them.

Hotwheels- fedex ground for 30 lbs to your place is $23. Would you mind an even $30. I imagine it's alloy only because I think Currie makes all their stuff top quality. My paypal is gkmissingca@netzero.net

[sfazr2]

wow, giving away a free axle and no takers. Guess it doesn't fit anyones rig?

[hotwheelsYJ]

I forgot about this, let me double check my measurements and get back to you on Wed.

TIA

[hotwheelsYJ]

You have a PM :)