mrk_bluto
04-27-2005, 06:58 PM
I have a bad miss between 2500-4000 RPM. Recently rebuilt carb, new plugs, fuel filter, air filter, O2 sensor, checked out all emmision parts(good), coil resistances are good, timing is right, egr valve, PCV valve, new catalytic converter and muffler. Compression check (175, 175, 155, 180)
If I "feather" the gas through this range it will run good from 4000-6000 RPM.
O.K. I've shotgunned a lot of parts, (one change at a time) and am still at a loss. Could the low compression on #3 cause such a miss?
Anybody have any ideas?
Thanks.
If I "feather" the gas through this range it will run good from 4000-6000 RPM.
O.K. I've shotgunned a lot of parts, (one change at a time) and am still at a loss. Could the low compression on #3 cause such a miss?
Anybody have any ideas?
Thanks.