Jeep TH400 to model 20?

[mebolson]

I found an ad for a guy that says he has a factory adapter to mate the Jeep TH400 to a model 20 transfer case. Will this work for me to get rid of the quadrajunk that I have now? The adapter is a case and a bearing. Will I need to buy gears to make this happen?
Thanks,
Eric

[smitrock]

not a bolt on thing, the output shaft in the tranny is different for the qjunk vs the dana 20

theres a big difference in the length, bulltear from this site sells the adapter that is much better than the factory one.

[bohot]

i had the 400/quadra trac set up....the shaft in the tranny is a 10spline male that sticks out about 8 or so inches...i also had a 400/d20 set up...all you need to do is buy a 32spline dana 20 witha adapter and the correct shaft for the 400...if i remember right the quadratracs adapter and the dana20 were real similar...