Reading the uroc, arca etc rules for cages they state that all must be of six point or more design, and tie into the frame at all points. The front is a no brainer. The rear of my cage is basically a factory CJ hoop with middle and rear points tied together by a plate across the wheelwell top, not really near the frame.
How are people integrating this into the frame at the rear-most points? I don't just want it to get in the comps, but obviously for my own safety- and space is at a premium back there, I need room for a fuel cell and toolbox so not too sure about running straight through the floor of the tub in the center.
Anybody got some pics? I did search, but didn't get much.
Thanks!

Out of curiousity (and admittidely with no research :flipoff2: ) do those rules apply to CalRocs as well?

just get a bar bent that looks kinda like a J with a plate on top that has bolts that run through the existing plat sitting on the wheel well, then bolts to the side of the frame.

Yeah, I was thinking about that but don't know if there's room for tire clearance.
Should know soon enough.
Thanks