Anyone have a drawing of a 40 frame in ACad? Yes, i have searched. And yes i have seen the drawings on IH8mud, but wanted to see if anyone had anything better; especially since the ones on mud dont seem to have the correct overall length. Looking to layout some 4link drawings. Thanks in advance!

i looked a while ago, and did it manually. finally had my PC wipe it out after it was done. just finishing a 4 link front and rear to wheel next weekend.

PM me for pics etc.

Come on now.....someone out there must have something????

Umm, looks like you will be doing it yourself. Just suck it up and start measurung. That is what I'll be doing but in Solidworks.

I have old scans of different frames with metric measurements but no actual drawings.

Fawking Measure It