i asked this question in general discussion and got flamed hard. anyways, i wanna know about dana 44 front axles. i heard rumors about some 33 and spline axles and carriers out there for dana 44 front. is this true? if so who makes them? are they any good?also i was wonder which u-joints to run, ctm or ox joints? will b runnin it in a 94 chevy with 38's.thanks...



P.S. i do not wanna run a d60. i ran the 38's on a half ton and wheeled pretty hard and only blew spiders.i know i should run a 60 but i just got rid of one and im jst to stubborn to find a ford side 60.

33 slpine is mainly rear alxes, but someone may be able to cut you up some custom fronts, but its going to cost ya.
Just Load it with Warn/Supierior's and CTM's

more then lilely a waste.. seen many yokes go on 30 spline alloy stuff so more splines wouldnt of helped

cool thanks. probly just gonna buy dutchman or warns and ctms. thanks for yur help

hey NE-roktoy, what r the flatops from and how much?

hey NE-roktoy, what r the flatops from and how much?
http://www.partsmikeparts.com/steering.htm

Call that guy, he will hook you up.

you can get some usd flat tops for like 50 bucks at least i did. post in the wanted section.