First off, this is my first post on this board, so Hello to everyone.

Second, i have a question that im sure someone can answer...My windshield washer sprayer (on the hood) seems to be clogged. both holes were originally clogged. i was able to get one hole clean with a pin, the second hole is still clogged. it could be anything from salt mixed with water, wax, or mud. anything in particular to use to flush it clean. nothing seems to be working. is there an easy way to take it apart?

This guy has to be kidding me, what a fawkin joke, very very very:rainbow:

Oh man:flipoff2:

1) Find a river, stream, or creek that has a higher water level than
your hood.
2) Park with your hood under the water.
3) If parked in moving water, make sure you are facing upstream. This will
create a low pressure area behind the sprayer.
4) Leave your "rig" parked there for at least an hour.
5) When you return the low pressure should have removed the clogg. If not
start over at step #3

You don't want your stock sprayers any way. Run down and get some of those LED sparyers. :flipoff2: That way you will have that cool Fast and furious look.

On the other hand get into the Newbies check in here thread. Then hook up you air compresser to blow it out.