a complete (alternator, starter, pwr steering pump, pulleys, etc) running 351 cleveland. with full length headers, elderbrock intake, high volume oil pump. it's got the 2V heads. the only problem is low oil pressure when it worms up. i think it's the main or rod bearings becuz i replaced the oil pump on it with high volume and no change, oil's clean though. engine runs like a raped ape. it was in my 79 bronco and it move the 6200lbs like no ones buisness. im selling it to help finance another project and im looking for $400.00. motor is still in truck located in L.A.

Btt

btt

this thing has to go so i will throw in a c6 tranny and np205 t-case with it i just need it gone. i dont have a engine hoist so you have to pull. that's the running engine tranny and t-case for $400.00 come on somebody has to neeed this stuff.

If its the origional motor, it sounds like a 351M to me. Can you confirm?

it is definetly a 351c with small block c6. it's got 4bb holey with elderbrock intake and it's got the 2v heads. and the ports are huge smaller than the 4v but still huge compared to a 351w or 350 chev.