putting this up for a friend. axle is from a 79 f350, HPD60, drivers side drop, 5.13's, detroit, chromo inner shafts, kingpins are new, spindles are new in box from ford, brakes are new from ford, hubs are new, 35 spline lockouts (warn i think) , dont think the axle has been run since the above was added. doesnt have stub shafts/joints nor high steer arms, but everything else should be there. located in Tupelo, MS. He told me to ask $2500.00 for it, but im sure that is neg. contact Charley Knight at 662-213-9598. again this is in MS and I do not have pictures of the axle or anymore info. he doesnt have internet access so a phone call is probably the best. I can call and get BOM if needed or you call. width is stock.

thanks,
Zac Smith

ttt

Bump ....

Zac why not put this on the Taco?

Bump ....

Zac why not put this on the Taco?

was my plan at first but i think im going to build or draw out the plans and have a machine shop make a center section that accepts a 1.75" 40 splined shaft with special joints from CTM. will more than likely run dana 70 ring and pinion's. i just want rear steer and 44's and dont want to run rockwells to do it since the truck would have to be 9' tall to clear the top loader. plus i just want to see if it works :D