|
Silverbullet555 06-06-2005, 11:12 PM I am looking to replace the ball joints on my 88 Suburban 3/4 ton. JC Whiteny sells a greaseable ball joint at a reasonable price. Is there stuff any good or should I run for the hills? jeeplord 06-07-2005, 04:09 AM as long as you install it properly they should work fine. I've run a few greasable ball joints and been very happy Silverbullet555 06-07-2005, 09:14 AM Sweet. Gonecheenin 06-07-2005, 11:53 AM I personally swear by Moog Fleet-Tuff balljoints in a solid axle chevy They are kinda expensive but they are the only setup i know of with a upper ball joint that can be greased without removing the axle shaft (the grease fitting goes in at an angle) I've had a couple set's of these and the truck always ended up wore out before the Balljoints did (I kept them greased every oil change) Silverbullet555 06-07-2005, 05:41 PM Can the upper on the others be greased with a 90 degree fitting for the grease gun? | |