diaphragm clutch price

[Bindernut]

Alright, I realize this is gonna seem like a Newbie question, but I want a good price on a diaphragm style clutch. Need at minimum the pressure plate and driven member, bearings too is a plus. Who has the best price on this style of clutch? I don't want the 3-finger Dana type again, those are piss-poor design because the throwout fingers always bend and then the clutch doesn't release properly.

This is, of course, for an IH SV engine, looking for 11" size.

Thanks.

Sean

[jdjanda]

Originally posted by Bindernut
Alright, I realize this is gonna seem like a Newbie question, but I want a good price on a diaphragm style clutch. Need at minimum the pressure plate and driven member, bearings too is a plus. Who has the best price on this style of clutch? I don't want the 3-finger Dana type again, those are piss-poor design because the throwout fingers always bend and then the clutch doesn't release properly.

This is, of course, for an IH SV engine, looking for 11" size.

Thanks.

Sean

I heard on the BB that Car Quest has a complete 12" setup for around 2 bills. The topic is on the new V-bulletin

Joe

[Bindernut]

thanks joe. I used to get over to vbulletin and techtalk a lot, but got tired of telling people how to fit 31's or arguing about what grade of hardware to use for body mount bolts. I'll go look it up.

sean

[That Mick]

Why is the 3-finger Long style clutch so bad??
I've run many of them in diffent apps and not had trouble. If the Long clutch was so bad, why do they get used in damn near every heavy truck app I've seen????