Another victim of the move! The truck has:

360 v-8
NP435 4-speed
9" rear
dana 44 front
33" mudders
No pick up bed (I was going to install a flat bed)
runs
No smog ever needed!

Asking $700 obo. Vehicle is in Manteca, Ca. Call 408-545-3838 or e-mail

What transfer case is in it and what is the gear ratio?

It has the Dana 21, and I would assume 3.55 stock gears. I have a NP205 on the side of the house if you'd like to make a deal on that too.

hey do you have any pics of the truck got a buddy that interested in it. also are you firm on that price.

Sent you an e-mail with the pict. Price is OBO, but if you come buy it before the end of the month, I'll cut you a deal!

what does it need....

might be interested

pics?

i would like to see some pics of this beast. please send them to me at Gfbgreaser89@aol.com.


thanks,
the greaser

bump...pics?

don' know if its still 4 sale, but still interested. thanks

pm pics please or post them.

Please post your e-mail addresses and I'll e-mail you picts. I can't get the picture to work on this site. Truck is still for sale.

do you think you would trade for a cj5?

im kinda far away but...

lemme know.
brian

What shape is it in?
Motor?
Tranny?
Year?
Picts?

can i see pcs, interested, miniskis2000@sbcglobal.net

its a 59 cj5 with ?miles
its in fair to good shape. the only major rust i can find is in the floorboards, where the previous owner already made some temp. repairs.

this rig is all original...fhead 4cyl...t-90 3spd....d18 transfer case....d25 frt...d44 rear

it needs the following to be finished...

radiator
gas tank
brake job(system is complete, but i can't be sure it works correctly)
wiring hookup(it came to me in pieces(now about 85% complete.

new parts installed...windshield,oil cannister/filter, oil lines, battery, bikini top, body mounts, engine mounts, ignition switch, top end gaskets.

i have it advertised in this section under cj5 for sale or trade and there are pics in that thread

regards
brian

oh yeah, email is bcj13@hotmail.com... i'd like to see this beast, if you are interested.

regards
brian

p.s. i just checked and bakersfield is halfway between us...fyi

I'm interested, but I'd like to sell it for cash before next weekend. If it doesn't go by then, We can talk trades.

i would like some pics tanktrap@sbcglobal.net

sounds good dave,

keep me posted.

regards
brian

Does that Dana 18 have the PTO on it? I thought about it over the weekend and I'm very interested in the trade. Please let me know. Also what time frame are you looking in to?

hey dave,
i doesn't...didn't come with the truck. though i know you can bolt one right up. there was a guy on here not a month ago,(might still be in the "other" section) with a ramsey winch and pto setup for a couple hundred bucks(2-300). so i know they are around.

i am looking to trade sooner rather than later. if you wanted to load both our trucks on trailers and meet halfway somewhere, i would be up for that in the next few weekends

i'd like to know, what does this need to be 100%? i understand the bed is not there, thats fine. also, is it titled in california?
if you think of any more ?s, let me know...:)
thanks
regards
brian

p.s. could you send some pics to bcj13@hotmail.com...thanks. :)

found this pto for sale on the willstech page
http://www.willystech.com/parts/messages/20489.shtml

so we know they are out there!:)

ttt

Well, my plans included rebuilding the motor (start fresh), put a new chutch in, seal kit for NP435 and swap out the gears. Then I was going to put the project "bullet proof" lift kit from James Duff on it and some 35s. Yes it does have California title and is currently registered. Give me a call at 408-592-2345 after 5pm m-f and we can talk more.