This is a complete kit with all the mounting hardware, There made to fit scout II`s with auto`s or sticks but with a little bending could fit jeeps running scout dana 20`s ,,, They have stainless rods and are made using cnc machinery and are welded in a fixture to keep the custom fit up down to a minimum.
Introductory Price is $99 and a Set $12 shipping

Duffy
D.D.Machine
(360)779-2500

Paypal name is dd98370@hotmail.com (<<<< not a good email address)

would this kit also fit the scout dana 300? :confused:

no ,, it well fit scout 20 only,,,,,
scout dana 300 cases are the same as a jeep 300 but use a 1/2" bolt and jeep uses a 9/16" bolt...

I well be making jeep 300 stainless twin sticks in the next few weeks and I can look at making a few sets for the scout 300 cases... But first I have to finish a run of jeep CJ 20 sticks and then full size jeep 20 sticks.

Too bad, because I'm dropping my tranny and case to install a new clutch anyway. Do you think I could install the sticks after with the case in the truck? Thanks Hank.

yes you can install the sticks with the case in the rig,,, but you well need to pull the Tcase down and grind your shift rails... there is a great thread on 4x4wire.com on doing it to the D300 cases.

www.4x4wire.com/tech/dana300/
I think thats it
Duffy

I am also interested in a set for the D300

To make these fit in my scout will I have to tear into the case or can it be done while in the rig? for the 20?

Is the Scout II Dana 20 twin stick kit still available?? Is it still 99 plus 12 shipping? Does it come with a twin shifter boot?? I am about to get my front axle locked and this will be required for me to be able to steer. Could I bolt this on with t-case still in the truck?? Thanks!!