I just got it back from the shop yesterday. I had to air down to 1# and load up the bed with my spare sm420, t/c, six cases of wine and two neighbors sitting on the rear in order for the cage to clear the garage door by a 1/4 inch. The cruiser sits at about 82” and the garage door header is at 76”.

Recent mods: 350 TBI, power steering, 6 point cage. I can’t say enough about the expert craftsmanship of Roggy Enterprises. Bobs work is truly top notch.

Things needed before its trail ready: Wire up the chassis, t/c linkage & throttle cable.

Things need to be street legal: Who fawkin cares! I’ll sort all that out after my 1st CHP encounter, hahaha.

Lookin good, hope she rides as well!
Mike :fj: :jeep2:

It is really that tall???

My SO on 38.5's is only 83" tall...


Looks good though!!!

Now you get to add some dents and scratches :D

Well my measurements on the height might be a little off (I had a few brews by the time I got home) let's just say it's >80" but I was more concerned with how low I could sink it so that it would clear the garage. The cage does sit above the windshield frame by an inch or 2.

Scratches & dent's are the next mods for sure...

Bout damn time Keith! I was checkin it out a couple weeks back at Bob's shop, looks real sharp! And yeah, his cage is a good deal higher than the average cage.

Jeff

Lookin' good Kieth. Ya gonna be ready for the Clean-up Run:rasta:

You betcha Andy but weather permitting (remember 2 years ago) will determine which rig I'm in. The cruiser will be my 1st choice though.

alright keith! lemme know when your ready..p/s is done as far as fab work. just gotta bolt up the clip and get the pumps and pulleys sorted. come awn!!:rasta: