44044 question

[drummr]

ok so i did some searching around and i still haven't found the any answers to my question. so here goes. to my understanding 44044's are rancho wagoneer lift springs. here are my questons.
1 how long are they?

2 around how much lift do they give you?

3 do they flex well compared to all pros or marlins leafs?

4 what modifications do you have to do to make them fit?

thanks

-Lucas

[wizard_Drd]

A vehicle would be helpful. If its a Toyota, check the FAQ. http://www.pirate4x4.com/forum/showthread.php?t=173918

The dimensions are there as well.

[drummr]

haha sorry im a dumbass. yeah its a toyota. thanks for the link

[SJscouter]

im not sure about yotas but ive had problems with them bending bad if you have a heavy truck but the front of a toy would be fine.

[lincontaco]

from the yota faq's,

44044s are Rancho Jeep Wagoneer Lift Springs.

Length: 47” (Length is eye to eye)
Center Pin split (front/rear) 22.5"/24.5"
Bushing: 2 3/4” & 3”
Lift: 5.25 - 5.5” (Lift is approximate and uses 1.5” longer than stock shackles giving 3/4” of lift)
Cost: $250 (Cost is for both sides incl. shipping/give or take)

one thing to take note of, is that if you run the short side torwards the front you may need to rotate your knuckles since it will make the pinion point down more, they flex well on my tacoma, they would go into a neg. arch the first day i had them on the truck, and really bad now, (guess some bump stops are in need) I have horrible axle wrap up front since they have settled and im now continually taking out front u-joints/yokes. cant say anything about the marlin or allpro's.

[lucasxj]

where's the best place to buy them at?

[lincontaco]

where's the best place to buy them at?


i ordered mine from summit racing, i think they were 220-240 bucks if i remember correctly, just call around to find the best prices.