alright well i have had a flatfender come in to my hands, ialso have a bunch of yota parts and fullsize 44 and 14 bolt around house. so now i am looking to build my own frame and use a all toyota drive train with fullsize but wanted to know if there is n e one else out there that has seen or has already done it and i would also like to find out some info on biulding my own frome. all input with very appreciated.
thanx

dont have much imput, but it sounds pretty cool, personally i would skip the 4cyl, but thats up tp you, good luck

well i am open to sugestions i wouldnt mind a 350 but whats it going to cost me to get a running 350 and tranny and a case and what cases are low enough for me with 39s and 5.38's. i dont know much bout 350 as u can tell so once again i am kinda stuck rite now tryen to see witchway i should go towards :confused:

toy drivetrain in a flat fender?

Sacrilege!

find a FSJ 401 and go from there :flipoff2:

just another worthless post!

I think it would work well with a few things - first stretch the wheelbase maybe 20" mostly in the rear so you can fit some crawler gears (klune or double t-cases) and a rear driveshaft. You will need the low gears because of the size of tire to run on the 14 bolt. These guys run a 22re in a flatty: http://www.ottindustries.com/Willys_Story.html There is another guy on this BB that has a toy drivetrain in his flatty also, mudtruck44 link (http://www.pirate4x4.com/forum/showthread.php?s=&threadid=147756&perpage=25&pagenumber=1)

I run a full width 44 front and 14 bolt on my flatty and it looks good, cant say how well it performs yet though since it is still being built.

this guy also has some Toy running gear in a flatty: http://board.marlincrawler.com/index.php?topic=6472.0

if you have the stuff lying around, go for it, but if you're buying axles, I would go for Toy stuff.

ya i already ahve axles and am planing on building my own frame but i want to see some other built frames and see how they turned out and if n e one can give me some possible pointers when i start the build im plaing on running s 10 rear springs im not sure if i want them in front or back i am also thinken bout ford van springs so i might run van springs in front and s 10s in the rear but at the same time i am like well im biulding the frame i mite as well do my 4 link in the rear at the same time. but i need to just make up my mind and decide on somethen finally. :shaking: