bigrocksoffroad
08-10-2005, 10:14 AM
Got it in bolt on kit form now. No need to flare your own tubes.
This kit is necessary when doing a rear disc brake system or if you just want to eliminate the rear Load sensing Valve. Our new kit takes all the hassle out of installing the valve. This kit is entirely bolt in. All you have to do is disconnect the rear brake line from the master cylinder, thread in the long adapter line, then the new proportioning valve, the short adapter line, then connect your stock line back in with the union. Finally bleed the brake system. (You must also remove the stock load sensing valve.) This separates the front and rear brakes into two separate systems. $85.00
Parts Included:
2 hard lines, each with one metric and one standard fitting
1 metric union
New proportioning valve
http://www.bigrocksoffroad.com/images/IMGP7340_small.JPG
Give us a call to place an order or answer your questions. 360-567-3347
This kit is necessary when doing a rear disc brake system or if you just want to eliminate the rear Load sensing Valve. Our new kit takes all the hassle out of installing the valve. This kit is entirely bolt in. All you have to do is disconnect the rear brake line from the master cylinder, thread in the long adapter line, then the new proportioning valve, the short adapter line, then connect your stock line back in with the union. Finally bleed the brake system. (You must also remove the stock load sensing valve.) This separates the front and rear brakes into two separate systems. $85.00
Parts Included:
2 hard lines, each with one metric and one standard fitting
1 metric union
New proportioning valve
http://www.bigrocksoffroad.com/images/IMGP7340_small.JPG
Give us a call to place an order or answer your questions. 360-567-3347